![]() Roll the tool rest table 0-40 degrees according to the degree of the back Angle of the side edge of the milling cutter, so that the accessory table of the end milling cutter can adjust the suitable grinding point. Adjust the end milling cutter to a higher base than the grinding wheel. ![]() Insert the FB elastic sleeve into the conical hole of the milling cutter accessory table, insert the end milling cutter with appropriate diameter scale into the R sleeve and fix it, so the spiral end milling cutter will no longer roll. ![]() Replace the original tool rest table with a milling tool grinding accessory table. Carbide square end milling cutter side edge grinding: After grinding, grind the other edge tooth with the tool rest indexing device by turning the tool 45 degrees (4 edges) or 0 degrees (2 edges).Ģ. With the original tool holder R8 chuck clamp milling cutter handle, according to 90° horizontal rolling carbide square end mills grinding accessories, unplug the limit screw, the tool holder can be reversed 360 degrees to the position of the grinding end edge, and then according to the point of view of the end cutting edge, grinding end edge of the Angle of the slope, pay attention to the way of grinding. Grinding of carbide square end milling cutter end: The grinding method of end milling cutter is as follows:ġ.
0 Comments
Leave a Reply. |